Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer…
view full answer...Hey Eric, so to find out if the Lippert Manual Pull Out Steps #LC432682 are going to work with your 2022 Forest River Rockwood Freedom Camper you're going to need to locate the space available underneath your camper that lines up with the door…
view full answer...The Trailer Valet RVR3 Remote-Controlled Trailer Dolly - Wireless Remote - 3,500 lbs #TVRVR3 you referenced has a tongue weight capacity of 350 lbs max. The mounting bracket with attach directly to your trailer tongue and has a quick release cotter…
view full answer...The MORyde Rubber Equalizer #MR87ZR could absolutely be used on an enclosed trailer. The 8K rating would be per axle. It might be more accurate to say that these equalizers can be used on axles 8K and under. So if your trailer is 10K gross weight, a…
view full answer...To add a hitch to your 2024 Jeep Grand Cherokee L, I recommend the Draw-Tite item #DT42GR. This hitch is custom fit and bolts to your Jeep with included hardware. This is a class III hitch with a 2" receiver. It has a 7,500 lbs towing capacity…
view full answer...The mounting bracket for the #TV34FR is actually identical to the bracket on the #TV64FR that you were looking at. The holes are 1" apart on center vertically, and 5-1/2" apart horizontally. I have attached a picture for your reference.
view full answer...There is no weight rating for the Mounting Bracket, part #TV-0002. It is designed to replace the bracket for the Trailer Valet Trailer Jack, part #STC-V211. The Trailer valet has a weight capacity of 500 lbs. You may be able to install a different…
view full answer...Since the MORryde AllTrek 4000 Equalizers #MR29DR sits inside the middle hanger like a standard equalizer you'd want to use the MORryde X-Factor Crossmember for Standard Frame Hangers #MR33WR. This crossmember will use your wet bolt and come with…
view full answer...Thanks for the photo and good information! The Curt Spectrum Trailer Brake Controller #C51170 doesn't come with a universal pigtail but that can be acquired with part #C51515. Then all you need to do is match the following wires from the pigtail…
view full answer...The Trailer Valet #TV94FR has a 3000 lb lift capacity, so it'll handle a 1000 lb tongue weight easily. Trailer Valet doesn't recommend using an impact driver because the increased torque they deliver could dramatically shorten the lifespan of…
view full answer...90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
view full answer...The Optronics Flexible LED Light Strip #UCL90CB that you referenced does put off a bit off a purplish hue. If you check out the two pictures I attached you'll see what I mean. It still puts out enough light to be useful though so it would work…
view full answer...Filter Your Search
Contact and Help